More Masks!

Hey folks, as promised I have some updates on the second mask I've been working on, now that the RWBY one is finished.

The process was pretty much the same as the last one, but the shapes were a bit more organic this time which made things interesting.

This is the dragon priest mask, from Skyrim. I don't know a ton about skyrim, but I do know this is a pretty cool mask. Just like last time, I put together the pattern on a wig head using cardstock. The shaping was a bit harder to figure out and I had to tweak things a bunch to get them right, but ultimately I had a viable pattern to use.

You know what comes next, make it again out of paperboard and cover it with worbla!

A note about using worbla over  detail pieces: start in the middle and work your way to the edges to avoid any bubbles.
Another note along the same lines: Popsicle sticks are great for pressing the worbla into the details. You can see how I did it with the eyes and cheekbone ridges.

The mask construction is done! Now it's time to add the loops for the straps to attach to. I did kind of a bad job of explaining how I made those last time so I tried to take pictures of the steps this time.

Start with some heavy-gauge wire. I think the wire I used was gauge 16, I wouldn't recommend anything thinner than that. You start by folding your piece of wire into a rectangle with the two ends overlapping on one side. Then take a long rectangle of worbla (I used two layers, and would recommend you do too for extra stability), and put it through your wire loop. Then heat up your worbla and fold it around the wire loop, over the edge where the two raw ends are. Then heat it up again and mush the soft plastic into the surface where the loops need to go. You definitely want a layer of worbla on the surface underneath the loop, because the worbla will stick better to other worbla than most other surfaces.

And that's were are now. I'll be priming and sanding for a few days and then it's on to painting! Huzzah!